CLAMP BARS on Magnetic sheet metal brake Magnabend sheet metal folding machine
The easy exchangability of clampbars is a very strong feature of the Magnabend concept.
The illustration below shows:
A Slotted Clampbar,
A Plain Clampbar,
A Narrow Clampbar,
A Clampbar Short Set.
You don’t necessarily need all of these clampbars. In fact you can do nearly all your sheet metal folding with just the slotted clampbar!
Magnabend Magnetic sheet metal brake As well as for making boxes and trays the Slotted Clampbar is also fine for plain folding.
It might be thought that the existence of the slots would mar the finished fold where the bend spans across the slots. But the slots do not show up at all, even when folding very thin sheet metal.
Magnabend Magnetic sheet metal brake For making boxes and trays the slotted clampbar allows for ALL SIZES up to 635mm long. (For a very few sizes it is necessary to use an end of the clampbar as a virtual slot). The boxes and trays can be up to 50mm deep. For deeper boxes it is suggested to make the box with separate end pieces, see this section.
However if you really need to make deep boxes on Magnabend Magnetic sheet metal brake out of a single piece of sheet metal then you will need the set of Short Clamp bars. There is no limit to the depth of box that can be made with the short clamp bars.
If you don’t need to make boxes at all then you may choose to furnish your machine with just the Plain Clampbar.
Magnabend Magnetic sheet metal brake The Narrow Clampbar might be needed for some smaller specialised shapes.
Post time: Mar-27-2023